Set the right time
11
The BeoSound 1 has a
If you want to make use of the
Set the built-in clock
You must set the
While BeoSound 1 is in standby,
20.00press and simultaneously and hold until the time is shown in the display. Both the digits and the dot are blinking
If no time is set, the display will | |
| show lines instead of digits |
| Press or to find the correct |
14.25time. Holding down or will accelerate the change in numbers
STORE Press STORE to store the correct
15.00time. The time is briefly shown in the display
See the stored time
The stored time can be shown briefly in the display.
Press both and shorty. The
14.25time is shown briefly in the display, the dot is blinking
STANDBY While BeoSound 1 is in standby,
14.25press the STANDBY button to see the time in the display
NOTE! Pressing the red button on the Beo4 remote control will show the time in the display