Advanced Adjustments 16
To exit the menu system:
1 Turn the Contrast knob until the Save
Changes dialog appears in the OSD:
2 Turn the Brightness knob to toggle between
Yes and No. Select Yes to save the changes,
select No to exit without saving the changes.
3 Turn the Contrast knob to exit.
See also: Menu Exit, later in this chapter.
A word about thememory system
As explained in the introduction of this manual,
the memory of the display can hold four different
scanning formats. Each scanning format is
characterized by the following parameters:
Horizontal sync. frequency, horizontal sync.
polarity, vertical sync. frequency, and vertical
sync. polarity.
If the parameters of the connected signal are the
same of the parameters of one of the scanning
formats in memory, the automatic scanning
system selects this scanning mode. This means
the image on the display adapts to all the
adjustment values stored in this scanning mode.
In case the connected sync signal doesn't match
one of the stored scanning modes, the automatic
scanning system selects the nearest scanning
mode. This means the scanning mode of which
the stored sync frequencies are as close as
possible to the sync frequencies of the connected
signal.
When you change one or more adjustment
values, and you decide to save the changes upon
exit of the menu system, the changed values are
stored in the actually selected scanning mode.
This means the actually selected scanning
mode is overwritten by the new adjustment
values.