Introduction 6
The conformity calibration, as well as the
complete adjustment of the display, can be
performed by means of the remote, user-friendly
MediCal® software package. MediCal, which runs
under Microsoft Windows NT, is especially
developed to adjust and check BARCO’s medical
displays.
A lot of adjustments can also be done on the
monitor itself, by means of an extensive on-
screen menu system, accessible from the rear
panel controls.

Calibration and

adjustments

Power saving system The MGD 2621 P is equipped with a power
saving system.
When left idle for a certain time, the computer,
connected to the display, will power down the
display in several steps. The power saving
system can be switched on or off during the
installation or adjustment of the display.
This system requires a computer imaging board
that supports power saving management.
Important: It is absolutely necessary that the
impedances of imaging board and display are the
same. If not, the image quality will be inferior.
The MediCal software and the X-Rite DTP92
sensor are not delivered with the display.
MediCal can be ordered separately.
About the manuals
This guide is meant for people who want to install
and use the MGD 2621 P display, as well as
people who need to install and adjust the display.
Chapter 4, Adjustments, is meant for this second
category only, because it describes actions and
procedures that require a technical skill to be
performed properly.
The use of the software MediCal is described in
the MediCal User’s Manual.