Bard 357-93-E manual Unit Service Access Overview

Indoor Blower Performance - CFM at 230 or 460 Volts

	WL18		WL30		WL42
ESP	WL24					WL60, WL70
			WL37		WL48
in	WL25
H2O	Dry/Wet Coil	High Speed	Low Speed	High Speed	Low Speed	High Speed	Low Speed
		Dry/Wet Coil	Dry/Wet Coil	Dry/Wet Coil	Dry/Wet Coil	Dry/Wet Coil	Dry/Wet Coil
0	1020/975	1395/1315	950/935	1885/1800	1650/1600	2200/2000	1600/1450
.1	960/905	1340/1270	930/915	1770/1665	1550/1500	2100/1900	1525/1375
.2	865/800	1285/1190	910/885	1635/1550	1450/1400	2000/1800	-/-
.3	820/735	1205/1100	855/830	1500/1400	1350/1300	1875/1700	-/-
.4	735/650	1110/1000	800/755	1370/1285	1300/1175	1775/1600	-/-
.5	615/535	1005/870	-/-	1250/1150	-/-	1650/1475	-/-

Above data is with 1" standard disposable filter and 1" washable filter.

For optional 2" pleated filter - reduce ESP by .15 in.

See installation instructions for maximum ESP information on various KW application.

Electric Heat Table - Refer to Electrical Specifications for Availability by Unit Model

Nominal		At 240V (1)				At 208V (1)				At 480V (2)			At 460V (2)
KW	Kw	1-Ph Amps	3-Ph Amps	Btuh	Kw	1-Ph Amps	3-Ph Amps	Btuh	Kw	3-Ph Amps	Btuh	Kw	3-Ph Amps	Btuh
5.0	5.0	20.8		17,065	3.75	18.0		12,799
6.0	6.0		14.4	20,478	4.50		12.5	15,359	6.0	7.2	20,478	5.52	6.9	18,840
8.0	8.0	33.3		27,304	6.00	28.8		20,478
9.0	9.0		21.7	30,717	6.75		18.7	23,038	9.0	10.8	30,717	8.28	10.4	28,260
10.0	10.0	41.7		34,130	7.50	36.1		25,598
15.0	15.0	62.5	36.1	51,195	11.25	54.1	31.2	38,396	15.0	18.0	51,195	13.80	17.3	47,099

(1)These electric heaters are available in 230/208V units only.

(2)These electric heaters are available in 480V units only.

Unit Service Access Overview

ELECTRIC HEAT ACCESS PANEL

ELECTRICAL CONTROL ACCESS PANEL

COMPRESSOR ACCESS

￿ 15"

￿

￿

￿

Model WL with Left Side

Control Panel

￿

￿	ELECTRIC HEAT
	ACCESS PANEL

ELECTRICAL

￿ CONTROL ACCESS PANEL

COMPRESSOR

￿ ACCESS

Model WA with Right Side

Control Panel

NOTE: A 15-inch clearance between units is required when model WL and model WA are mounted side by side. This provides for proper service access to condenser fan and motor shroud assembly and adequate condenser air flow.

Form No.	S3279-206
Supersedes	S3279-106
Page	9 of 12