Initial set-up of your oven
Selecting manual operation mode
After your appliance is connected to your mains supply for the first time (or after a
oTo select manual operation mode, press the program button (12) for three seconds. The oven in use symbol (15) will light in the display.
Setting the time of day
After your appliance is connected to your mains supply for the first time, you must set the time of day before you can use the oven.
oMake sure the oven is in manual operation mode (as outlined above).
oPress the program button (12) once to set the time of day. Whilst the decimal point symbol (16) is flashing, use the plus (13) and minus (11) buttons to set the correct time of day.
oWhen the correct time of day is shown on the LED display, release the plus and minus buttons and wait a few seconds. The decimal point symbol (16) will stop flashing and the oven is ready to use.
Before first use
oTo remove any residue from the oven that may have been left from the manufacturing process, you should select the fan oven function and set the thermostat to its maximum temperature setting.
oIt is perfectly normal for a smell to be produced during this process.
oYou should make sure that any windows in the room are left open during this process.
oIt is advisable for you not to remain in the room whilst the burning off process is taking place.
o You should leave the oven on maximum setting for 30 – 40 minutes.
oAfter the oven cavity has cooled, it should then be cleaned with warm soapy water, using either a sponge or soft cloth. No abrasive cleaners should be used.
11
