Baxi Potterton Condensing Combination Boiler manual Flue/Heat Exchanger Thermostat Sensor Fig

Electrical

PlugFlue/Heat Exchanger

Thermostat Sensor

Fig. 83

Flow Pipe

Central Heating

Temperature Sensor

14.0Changing Components

14.8Flue/Heat Exchanger Thermostat Sensor (Fig. 83)

1.Ease the retaining tab on the sensor away and disconnect the electrical plug.

2.Turn the sensor 90° anticlockwise to remove - it is a bayonet connection.

3.Reassemble in reverse order.

14.9Water Pressure Sensor (Fig. 85)

1.Drain the primary circuit.

2.Disconnect the two wires from the sensor.

3.Undo the nut on the flow pipe securing and sealing the sensor.

4.Remove the sensor, examine the sealing washer, replacing if necessary.

5.Reassemble in reverse order. The component is not polarised - either wire will fit each terminal.

14.10Central Heating Temperature Sensor (NTC) (Fig. 84)

1.Ease the retaining tab on the sensor away and disconnect the electrical plug.

2.Unscrew the sensor from it’s pocket and reassemble in reverse order. The plug will only fit one way.

14.11Safety Thermostat (Fig. 85)

Fig. 84

Pressure Sensor

Fig. 85

Safety Thermostat

Plate Heat

Exchanger

DHW Temperature

Sensor

1.Pull the plug off the thermostat.

2.Remove the screws securing the thermostat to the mounting plate on the flow pipe.

3.Reassemble in reverse order, ensuring that the plug is pushed fully on.

14.12DHW Temperature Sensor (NTC) (Fig. 85)

1.Turn off the mains cold water supply tap and draw off the residual domestic hot water.

2.Ease the retaining tab on the sensor away and disconnect the electrical plug.

3.Unscrew the sensor from the plate heat exchanger manifold. Examine the sealing washer,replacing if necessary.

4.Reassemble in reverse order. The plug will only fit one way.

42© Baxi Heating UK Ltd 2012