Operating Instructions

oChannel priority ON/OFF switch (option upwarts serial no.: 46)

Call up function SF 18 using the MDE key. The following displays appears :

Top line

SF 18

Bottom line

CS channel number

Using the kHz (steps of 1) or MHz (steps of 10) switch, select the desired channel. Store the channel by pressing the STO key. Several channels can be selected on priority channels.

oSquelch fast mode (upwarts serial no.: 46)

Call up function SF 19 using the MDE key. The following displays appears :

Top line

SF 19

Bottom line

0 or 1

0 = Squelch fast mode OFF

1 = Squelch fast mode ON

Select the function using the kHz switch. Store the value by pressing the STO key.

Becker GK 415 - ( )

8Frequency selector switch Switches the indicator frequency

(inner rotary switch)

in 25 kHz steps or the storage

 

channel by 1 step in each case

 

upwards or downwards, without

 

carry over.

Operating instructions

oSwitching on the portable VHF station

Switch on the portable VHF station using the ON/OFF switch (rotate volume control clockwise).

Both LCDs must show the numbers 188.88 flashing (unit test approximately 2 seconds). If the test is positive, the portable VHF station automatically switches to the mode which was selected before switch-off. If the test is negative, the LCD flashes for approximately 5 seconds. A fault report can be called up by pressing the store key. After approximately 5 seconds the portable VHF station automatically switches to the mode which was selected before switch-off.

The following fault signals are possible :

E1 Processor defective

E2 Synthesizer failed

E3 Fault in EE-PROM

E4 Controller (PIC) audio board defective

The various modes are comprehensively described in the annex to the general operating instructions.

Page 30

Issue 05/2000

Issue 05/2000

Page 11