Operating Instructions
oMode 1 (standard mode)The last displayed active and preset frequencies appear in the LCD dis- play.
The preset frequency (bottom line) is set using the MHz and kHz frequency selector switches.
When the exchange key is pressed, a change from the active to the preset frequency occurs. A further operation of the key cancels the frequency change.
Pressing the STO key in any mode initiates a store operation. CH and the last called up storage channel appear flashing in the bottom line. A different storage channel can be selected in steps of 1 using the kHz frequency selector. The MHz frequency selector enables storage channels to be selected in steps of 10. If a free channel is selected, one in which no frequency has as yet been stored, the letter F (free channel) appears in the bottom line before CH. The storage operation is ended by again pressing the STO key, which stores the active frequency displayed in the top line in the channel shown in the bottom line.
Becker GK 415 - ( )
oSetting the temperature display in °C or °FNot activated in the portable VHF station. SF7 is not displayed
oSwitching on the scan functionCall up function SF 8 using the MDE key. The following display appears :
Top line | SF 8 |
Bottom line | 0 or 1 |
Select the required function using the kHz switch and store the selection by pressing the STO key.
0 = scan function off
1 = scan function on
If scan function is not activated, than functions SF9, SF13 and SF14 are not displayed.
oSetting the hold time in the scan function (if funtion SF8 acti- vated)Call up function SF 9 using MDE key. The following displays appear :
Top line | SF 9 |
Bottom line | 0.0 to 60.0 |
The hold time can be set as required between 0 and 60 seconds using the kHz switch. The set value is stored by pressing the STO key.
Page 16 | Issue 05/2000 | Issue 05/2000 | Page 25 |