Beckett CF 1400 Wire the burner, Typical wiring, Instruction Manual - Model CF1400 Oil Burner

Instruction Manual – Model CF1400 Oil Burner

Wire the burner

Install the burner and all wiring in accordance with the National Electrical Code and all applicable local codes or requirements.

Wire the burner in compliance with all instructions provided by the appliance manufacturer. Verify operation of all controls

Do not by-pass any safety control. By-passing a safety control could result in severe personal injury, death or substantial property damage.

in accordance with the appliance manufacturer's guidelines.

See Figure 10 for a typical wiring diagram, with R8184 oil primary, for reference purposes only.

The CF1400 burner is available with many different wiring configurations. Refer to the wiring diagram shipped with the burner for the actual wiring applying to your burner.

Electrical shock hazard - can cause injury or death. Disconnect power before installing or servicing. Provide ground wiring to the burner in accordance with the National Electrical Code.

Figure 10 – Typical wiring		H	N	G	Power supply			Field wiring
					120v/60 hz
								Factory wiring
Legend
FD	Fused disconnect, by others	FD					BK = black	OR = orange		WH = white
							Motor M1 wiring 14 ga		All other wiring 16 ga
LM	Limit controls, by others
O P	Operating controls, by others			LM	OP
PR	Oil primary control, R8184 typical
CC	Flame sensor, cad cell typical
TM	Delay timer				BK
TR	Ignition transformer			PR		BK			TR	WH
M1	Burner motor
S1	Oil valve				T
S2	Redundant oil valve — supplied
	only if burner is equipped with				T
	type H fuel unit.
T-T	24-volt thermostat/limit terminals					TM		S1
										WH
F-F	Cad cell flame sensor terminals				OR	OR
					OR	T
		CC			F
								M1
					F	BK				WH
					WH
					WH
										1411o
10								Form 6104 BCF14N-R0299