4Gas Cylinder Information Beefeater Barbecues
Gas Cylinder Safety Information
This appliance is designed to be used with a gas cylinder not exceeding 9KG (20lbs) capacity.
Standard POL Regulator
Fig 1 | Gas Shutoff Valve |
The Gas cylinder must be constructed and marked in accordance with specifications for LP Gas Cylinders of the:(USA) U.S. Dept. of Transportation (DOT) or the National Standard of Canada, CAN/CSA - B339, Cylinders, Spheres or Tubes for the transportation of dangerous goods.
The gas cylinder supply valve must be turned off when the appliance is not in use.
Tighten in this direction
Regulator and hose
Bleeder valve screw
Gas Cylinder
Gas cylinders must be stored outdoors, out of reach of children and must not be stored in a building, garage or any other enclosed area.
The gas cylinder used must incorporate a safety collar to protect the valve assembly.
Important:
Protector cap
Quick Connect Regulator
Fig 2 | Gas Shutoff Valve |
When disconnecting and removing the gas cylinder for the purpose of refilling, always observe the following procedure.
Ensure that all gas control valves on the appliance and the gas cylinder are turned off before disconnecting the gas line from the cylinder.
Do not smoke or use a naked flame near the appliance or gas cylinder while disconnecting the gas line between the appliance and gas cylinder.
Tighten in this direction
Regulator and hose
Bleeder valve screw
Gas Cylinder
Remove the gas cylinder from the enclosure before disconnecting the gas line from the appliance.
Tighten all connections before placing the gas cylinder back in its enclosure.
The Gas Leak Testing Procedure should be conducted every time the gas cylinder is refilled and reconnected to the appliance - before using the appliance.
Regulator Connection (Fig 1 & 2)
1.Check that all control knobs are in the ‘Off’ position.
2.Make sure the cylinder valve is off by turning the valve knob clockwise.
3.Remove the protective cap from the cylinder if present.
4.Leak test the connection with a soapy water solution. (See Gas Leak Testing Procedure)
Hose and regulator replacement must be a genuine part specified for this appliance and is
obtainable from your nearest BeefEater stockist.
Gas Leak Test Procedure
Use the following procedure to check for gas leaks.
Never use a naked flame to check for gas leaks.
Protector cap
1.In a small container, mix up a solution of water and detergent or soap. Mix the solution well.
2.For LPG make sure that the gas supply valve on the gas cylinder is turned on. For Natural gas make sure that the gas line is correctly fitted to the appliance.
3.Make sure that the gas control valves on the appliance are all turned off.
4.Using a brush or spray bottle apply the solution to the gas line and each join in the gas line. See Fig 3.
5.Bubbling of the solution will indicate that there is a leak present.
6.
7.If a leak persists then contact your distributor or the manufacturer for assistance.
Fig 3
