ULTRALINK UL2000M

7.After a second blink pause, an additional blink code is given as a confirmation:

A successfully stored frequency is signaled with 2 slow blinks. The transmitter leaves the programming mode.

If the LED blinks quickly 5 times, the frequency was not stored. In this case, start anew with step 2.

If no entry is made for more than 5 seconds (either on the selection switch or by pressing the POWER button), the LED blinks quickly 5 times, and the programming mode is aborted.

8.Disengage the MUTE switch.A user-assigned frequency is automatically stored in the user preset (Preset 1)!3.2.4 PresetThe ULM2000 lets you work with 4 presets, each with 8 channels.

Factory presets (Presets 2, 3 and 4)

In the ULM2000, there are 3 factory presets (each with 8 interference-free channels). That means that all 8 channels of one preset can run simultaneously with 8 different transmitters and receivers without causing interference to one another.

The channels in the 3 factory presets are all assigned to different frequencies. This way, you can always select a frequency range that assures the best signal transmission.

The following table shows which frequencies are stored in the factory presets.

CHANNEL

PRESET 2

PRESET 3

PRESET 4

1

798,700 MHz

798,400 MHz

798,100 MHz

2

799,950 MHz

798,950 MHz

798,650 MHz

3

800,650 MHz

799,800 MHz

799,500 MHz

 

 

 

 

4

801,050 MHz

801,450 MHz

801,150 MHz

5

802,850 MHz

803,250 MHz

802,950 MHz

 

 

 

 

6

804,500 MHz

803,650 MHz

803,350 MHz

7

805,350 MHz

804,350 MHz

804,050 MHz

8

805,900 MHz

805,600 MHz

805,300 MHz

Tolerance 0.005%

Table 3.1: Factory preset frequencies (presets 2,3 and 4)

User preset (Preset 1)

Preset 1 is meant for the user. Frequencies of your own choice can be stored in the 8 storage slots of this preset.

If you have not stored any of your own frequencies, the frequencies stored in the user preset (Preset 1) are identical to the frequencies stored in Preset 3.

Loading a preset

1.Engage MUTE. The transmitter can now be switched into the programming mode.

2.Turn the selection switch to 0 and confirm your selection by keeping the POWER button pressed for 2 seconds. As a confirmation, the LED blinks slowly once and then once again with medium tempo. The transmitter is now in the programming mode and waits for you to enter a one-digit number.

3.Select the desired preset number on the selection switch, e.g. 3 (possible choices: 1 - 4). If a valid selection is made, the LED blinks once quickly to confirm your selection. This way, you can be sure that a correct value is entered (in regard to the selection of presets, Mic Gain and Auto Mute) even before confirming your selection.

Selecting 5 or 6 changes the Mic Gain setting (ch. 3.2.5). Selecting 7 or 8 changes the Auto Mute settings (ch. 3.2.6). Values 9 and 0 are invalid.

4.Confirm your selection by briefly pressing the POWER button.

5.If the selection you made is valid, the LED blinks quickly once again. An invalid selection is indicated with 5 quick blinks, and the unit is immediately no longer in the programming mode. In this case, start anew with step 2.

After a brief break, a second blink code is given: The LED blinks according to the value selected (for example, in this case 3 times) with medium tempo.

14

3. ULM2000 MICROPHONE