ULTRALINK UL2000M
If the receiver is not powered on, no status is indicated. Briefly pressing the POWER button will neither turn the transmitter on nor off!
3.3.2Transmission frequency1.Turn the selection switch to 9. The position of the MUTE switch is irrelevant.
2.Briefly press the POWER button.
3.Just like during programming, 6 blink
The value 0 is signaled by a very short blink of the LED, and you will easily tell a 0 from a 1.
If the receiver is not powered on, no status is indicated. Briefly pressing the POWER button will neither turn the transmitter on nor off!
3.3.3Preset1.Make sure that the microphone is not set to mute (MUTE switch is set to OFF).2.Turn the selection switch to 1, 2, 3 or 4 and confirm your selection by briefly pressing the POWER button.
3.The LED indicates the preset number with the corresponding number of
1.Make sure that the microphone is not set to mute (MUTE switch is set to OFF).
2.Turn the selection switch to 5 or 6 and confirm your selection by briefly pressing the POWER button.
3.The LED indicates the Mic Gain status with the corresponding number of
1.Make sure that the microphone is not set to mute (MUTE switch is set to OFF).
2.Turn the selection switch to 7 or 8 and confirm your selection by briefly pressing the POWER button.
3.The LED indicates the Auto Mute status with the corresponding number of
3.5 ULM2000 level setting
To optimally set the level on your ULM2000, the High Gain or Low Gain setting has to be set to the level of the signal being transmitted (ch. 3.2.5).
Adjust the gain control in the microphone channel of your mixing console so that the peak LED lights up only occasionally or never at all. The EQ controls in the microphone channel should be set to
3. ULM2000 MICROPHONE | 17 |