ULTRALINK UL2000M

For the Auto Mute function to work, it has to be activated on both the transmitter and the receiver!

Activating/deactivating the Auto Mute function

1.Engage MUTE. The transmitter can now be switched into the programming mode.

2.Turn the selection switch to 0 and confirm your selection by keeping the POWER switch pressed for 2 seconds. As a confirmation, the LED blinks slowly once and then once again with medium tempo. The transmitter is now in the programming mode and waits for you to enter a one-digit number.

3.Select one of the following two digits on the selection switch:

Activate Auto Mute: select 7Deactivate Auto Mute: select 8

If a valid selection is made, the LED blinks quickly once to confirm your selection. This way, you can be sure that a correct value is entered (in regard to preset, MicGain and Auto Mute selection) even before confirming your selection.

Selecting the values 1 through 4 changes the preset settings (ch. 3.2.4). Selecting 5 or 6 changes the Mic Gain settings (ch. 3.2.5). Values 9 and 0 are invalid.

4.Confirm your selection by briefly pressing the POWER button.

5.If the selection you made is valid, the LED blinks quickly once again. An invalid selection is indicated with 5 quick blinks, and the unit is immediately no longer in the programming mode. In this case, start anew with step 2.

After a brief break, a second blink code is given:Auto Mute activated: the LED blinks once at middle tempo.Auto Mute engaged: the LED blinks twice at middle tempo.

If no entry is made for more than 5 seconds (either on the selection switch or by pressing the POWER button), the LED blinks quickly 5 times, and the programming mode is aborted.

6.After a second brief blink break, an additional blink code is given as a confirmation:

Two slow blinks signal that the Auto Mute setting was changed. The transmitter leaves the programming mode.

If the setting for Auto Mute could not be stored, the LED blinks quickly 5 times. In this case, start anew with step 2.

7.Disengage MUTE.

3.2.7 Turning the microphone off

To turn of the transmitter, keep the POWER button pressed for 2 seconds. A long blink confirms that microphone is being turned off.

The transmitter stores the frequency and the channel settings. These parameters are restored to these same values the next time you turn the unit on.

3.3 Status query

While you are using your microphone, you may want to check the “transmission channel,” “battery condition,” “transmission frequency,” “preset,” “Mic Gain” and “Auto Mute” parameters. The status of these parameters can be checked without having to turn the microphone off and back on.

3.3.1Battery condition and transmission channel

1.Turn the selection switch to 0. The position of the MUTE switch does not matter.

2.Briefly press the POWER button.

3.Just like when powering the microphone on, the microphone status is indicated with medium-tempo blink codes:

battery condition:1 = battery is nearly empty . . .

5 = battery is fully loaded

selcted channel:1 = channel 1 is selected. . .

8 = channel 8 is selected

16

3. ULM2000 MICROPHONE