ULTRALINK UL2000M
5.2 Installation in a rack
The ULR2000’s antennae are located in the front of the unit. This allows unproblematic installation in a rack.
Each unit is delivered with a rack bracket and a connecting joint. This way, you can choose:
1.If you wish to install only one unit in a rack, mount a rack bracket to one of the sides. In this case, you will not need the included connecting joint. Now, install one side of the receiver into the rack.
2.To install 2 receivers in a rack, first connect the two receivers to one another at the bottom using the connecting joint. Mount one rack bracket on the left side of one unit and one rack bracket on the right side of the other unit. Now, both ULR2000s can be installed in a rack.
To assure good reception, if possible, install the ULR2000 as high in a rack as possible, so that the antennae protrude above the upper edge of the rack.
The ULR2000 requires one height unit (1 HE) for installation in a
Be sure that there is plenty of space around the unit for cooling and, to avoid overheating, please do not place the ULR2000 on top of power amplifiers or other
If you wish to install more than 2 units in a rack, please make sure that there is enough space between them (fig. 5.1). The lower unit’s antennae may not perturb against the upper unit’s antennae. Otherwise, they could interfere with one another, causing a decrease in reception quality.
Fig. 5.1: Arrangement of multiple ULR2000s when installed on top of each other5. INSTALLATION | 19 |