EUROGRAND

5.3.3 Transposition

Use this function to transpose the selected sounds up or down by one octave. Depending on which sounds are used in a com- bination, the tranpose function can help make the sounds more homogeneous.

Example:

In a combination of GRAND PIANO 1 and STRINGS the STRINGS sound too low. In this case, it helps to transpose the STRINGS up by one octave.

+Please enter EDIT mode (see chapter 5.1) and select the following function.

Function: E3.3 (voice #1 transposed by an octave) E3.4 (voice #2 transposed by an octave)

Value: -1 ... 1

Description:

0:No transposition

-1:Transposition down by one octave

1:Transposition up by one octave

5.3.4Effect intensity

This function allows you to edit the effect intensity of the modulation effect for the selected sounds.

+Please enter EDIT mode (see chapter 5.1) and select the following function.

Function: E3.5 (effect intensity voice #1)

E3.6 (effect intensity voice #2)

Value:

 

0 ...

20

Description:

 

 

1 ...

20:

Effect intensity (default setting)

0:No effect

5.3.5 Reset

Use this function to reset all settings in layer mode.

+Please enter EDIT mode (see chapter 5.1) and select the following function.

Function: E3.7

Value: -

Description:

Press the +/YES button to execute this function.

5.4 Using the metronome

The EUROGRAND features a built-in metronome which can be used for practising or to make recordings with the internal music sequencer.

To use the metronome, please proceed as follows :

1)Press the METRONOME button to start or stop the met- ronome.

The metronome beats are shown by flashing dots on the display. At the beginning of a measure all dots light up simultaneously.

2)Keep pressing the SELECT button in the TEMPO/EDIT MODE section until the TEMPO LED lights up.

3)Use the two < > buttons to adjust a tempo of your choice.

4)Press and hold the METRONOME button while adjusting the number of beats per measure using the -/NO and +/YES button in the VALUE/SONG section.

The display reads:

+

 

04:

No stressed beats (default setting)

24,

34, 44, 54, 64, 74:

Quarter meter (e. g. 2/4)

38,

68, 78, 98, 128:

Eighth-note meter (e. g. 3/8)

5.4.1Metronome volume

Use this function to adjust the metronome volume.

+Please enter EDIT mode (see chapter 5.1) and select the following function.

Function:

E5

 

Value:

 

1 ...

20

Description:

 

 

1 ...

20:

Metronome volume (1 = low, 20 = high)

Proceed as follows for direct access to the metronome volume menu page.

1)Press and hold the METRONOME button, then hit the SE- LECT button in the TEMPO/EDIT MODE section.

+

The EDIT MODE LED lights up and the EDIT page E5 is dis- played.

Advanced operation

11