EUROGRAND
In our example the sounds „GRAND PIANO 1" and „STRINGS" are layered.
+To quit layer mode, press any button in the SOUND SELECT section. This will also select one single sound again.
4.2 Changing the sound character
You can change the sound character by using a room and a modulation effect as well as a brightness equalizer.
4.2.1Brightness equalizer
Use the brightness equalizer to change the sound character and make it softer or more brilliant.
1)Change the sound character with the BRIGHTNESS control as follows:
=Move the control to the left (SOFT) for a softer sound that is darker in tone.
=Move the control to the right (BRIGHT) for a more brilliant sound.
4.2.2 Room effects
The EUROGRAND provides room effects simulating four reverb rooms of different sizes. When you select a sound, the EUROGRAND also selects an appropriate effect. If required, however, you can always select any other effect. The following reverb room simulations are available:
ROOM: Simulates a small room.
HALL 1: Simulates a small concert hall.
HALL 2: Simulates a large concert hall.
STAGE: Simulates a typical stage ambience.
1)Keep pressing the REVERB button until the effect of your choice has been selected.
The active effect is shown by an LED lighting up next to the effect name.
+If none of the four LEDs lights up, the room effect is disabled.
2)Keep the REVERB button pressed while adjusting the origi- nal vs. effect signal ratio in the VALUE/SONG section using the
+ 
The display reads:
0 ... 20: Effect intensity
(0 = no effect, 20 = maximum effect)
3)If you want to restore the default settings, keep the REVERB button pressed, then press
4.2.3 Modulation effects
The EUROGRAND provides a modulation effect featuring four different types of effect. When you select a sound, the EUROGRAND automatically adds an appropriate effect for some of the sounds. If required, however, you can always select any other effect. The following modulation effects are available:
CHORUS: Chorus effect. „Widens" the sound.
FLANGER:
TREMOLO: Rapid, constantly repeated changes in the volume of the sound.
DELAY: Echo effect. Produces
the sound that decay over time.
1)Keep pressing the EFFECT button until the effect of your choice has been selected.
The selected effect is shown by an LED lighting up next to the effect name.
+If none of the four LEDs lights up, the modulation effect is disabled.
2)Keep the EFFECT button pressed while adjusting the original vs. effect signal ratio in the VALUE/SONG section using the
+ 
The display reads:
0 ... 20: Effect intensity
(0 = no effect, 20 = maximum effect)
3)If you want to restore the default settings, keep the EFFECT button pressed, then press
8 | Basic operation |