MIDI FOOT CONTROLLER FCB1010
Fig. 2.2: PRESET selection with DIRECT SELECT enabled
As this example shows, the DIRECT SELECT feature gives you a faster access to BANKS and PRESETS than without this function. Which option to use is entirely up to you. As long as you need the PRESETS from one BANK only, it will be advisable to disable the DIRECT SELECT function because this way you can recall a new preset with only one keystroke.
2.2 GLOBAL CONFIGURATION
In the GLOBAL CONFIGURATION menu you can set the parameters that apply to both the PRESETS and FUNCTIONS of your FCB1010 (e.g. MIDI channel selection, SYSEX SEND & RCV, DIRECT SELECT etc.). Keep the DOWN switch pressed during
The DIRECT SELECT LED in the display lights up.
You can use the UP and DOWN keys to navigate through GLOBAL CONFIGURATION main pages. Pressing UP leafs through the pages forward, pressing DOWN leafs the pages backward. A corresponding LED indicates what page you are on.
Fig. 2.3: GLOBAL CONFIGURATION menu structure
To leave GLOBAL CONFIGURATION menu, you need to press the DOWN/ESCAPE key for at least 2.5 sec.
+Only keeping the DOWN/ESCAPE key pressed for at least 2.5 sec. saves your newly entered settings!
2.2.1 DIRECT SELECT page
Keep the DOWN/ESCAPE key pressed while you power up the unit. This takes you to the GLOBAL CONFIGURATION menu; the green DIRECT SELECT LED lights up. To activate DIRECT SELECT, press 10/0 key. The red LED lights up. Now, you have
to confirm activating DIRECT SELECT to be able to directly select presets. To do this, keep DOWN/ESCAPE pressed for 2.5 sec. to exit GLOBAL CONFIGURATION. The display now shows “00”. Now you can directly select the presets, as described in ch. 2.1.2.
2.2.2 MIDI channel setting
To get from DIRECT SELECT to MIDI FUNCTION, press UP. The MIDI FUNCTION LED flashes correspondingly.
This is where you determine the MIDI channels that can be sent from the FCB1010 for various MIDI functions. You can assign different MIDI channels to MIDI functions, For example, you can control several pieces of equipment from your FCB1010. The selection of MIDI functions is done via footswitches 1 to 10/0. MIDI channel 1 is thefactory default for all functions.
|
|
1 | PRG CHG 1 |
2 | PRG CHG 2 |
3 | PRG CHG 3 |
4 | PRG CHG 4 |
5 | PRG CHG 5 |
6 | CNT 1 |
7 | CNT 2 |
8 | EXP A |
9 | EXP B |
10/0 | NOTE |
Tab. 2.1: Footswitches and assigned MIDI functions
sAfter selecting a MIDI function by pressing one of the footswitches, the respective footswitch LED starts to blink.
sPress UP/ENTER to confirm the selected MIDI function. The MIDI CHAN. LED lights up.
sChoose the MIDI channel for the selected function, either directly via footswitches 1 through 10/0 or by using the EXPRESSION PEDAL A. Your selection is shown in the display.
sPress UP/ENTER to confirm the chosen value and to go to the next level, or press DOWN/ESCAPE to cancel.
2.2.3 CONFIG page
The CONFIG LED lights up if you are on CONFIGURATION page. The following functions, recalled via the footswitches (as in table 2.2), are at your disposal:
2. PROGRAMMING THE FCB1010 | 7 |
