Behringer MIDI FOOT CONTROLLER FCB1010, Restoring factory presets, PROGRAMMING THE FCB1010

MIDI FOOT CONTROLLER FCB1010

Fig. 2.5: Sending a SysEx-Dump

2.7.2 Receiving SysEx dumps

To send back FCB1010 data stored on a sequencer/computer before, please follow the instructions below:

sConnect the MIDI OUT connector of your sequencer or computer to the MIDI IN connector of the FCB1010 (see fig. 2.6).

sKeep the DOWN switch pressed during power-up to enter the GLOBAL CONFIGURATION menu.

sPress UP until the CONFIGURATION LED lights up. Now the unit is in CONFIGURATION mode.

sPress footswitch #7 (SYSEX RCV) to “tell” the FCB1010 to wait for system-exclusive data (the footswitch LED lights up). Start the PLAYBACK function on your sequencer/ computer to play back the previously stored file. The foot- switch LED flashes while the FCB1010 is receiving data. Once the data have been received correctly, the LED dies out. Now your programs are back in the FCB1010’s memory. Quit GLOBAL CONFIGURATION mode by means of a long press on DOWN.

Fig. 2.6: Receiving a SysEx dump

2.8 Restoring factory presets

This function allows you to restore factory defaults of your FCB1010.

+In doing so, all preset settings made by you are overwritten!

Resetting your FCB1010 lets you restore various default settings that are optimized for use with BEHRINGER audio equipment. This is why there are three different key combinations that let you reload the desired defaults into the memory of your FCB1010￿￿￿￿￿￿. This key combinations￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿are shown in table 2.5:

1 + 6	V-AMP family products
1 + 7	BEHRINGER guitar amps
1 + 8	BASS V-AMP product range

Tab. 2.5: Reset key combinations

Keep the respective footswitches pressed for roughly 2.5 sec while powering up your FCB1010. The displays reads “09” to “00” and the points are blinking. When the points are no longer shown, your FCB1010 has been reset to factory defaults and is ready for operation.

2.9 Calibrating expression pedals A and B

Should you experience problems with exact MIDI controller data transmission while using the expression pedals, we recommend calibrating the pedals. Calibrating the pedals follows the complition of the FCB1010 self-test.

+All software versions 1.4 and newer allow for direct calibration by keeping the switches 1 and 5 pressed while powering up the unit. If your FCB1010 features the software version 1.4 or higher, skip the first 4 steps in the set of instructions that follow (i.e. start at point number 5). To find if your unit features version 1.4 or higher of the software, first try keeping the switches 1 and 5 pressed while powering up the unit. If nothing happens, start calibrating your FCB1010 beginning with the first step in the list that follows.

12 2. PROGRAMMING THE FCB1010