
Chapter 1 Introduction
Reset Button
Table
Alarm | Description |
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
LOS | RED LOS LED is ON when the PRI interface is detecting no | |||||||
| signal (pulses) on the network interface receiver. When a LOS | |||||||
| condition exists, the PRI interface transmits unframed all ones | |||||||
| (AIS) to the network. |
|
|
|
|
|
| |
ATTN | The ATTN (Attention) LED is amber and ON when the Remote | |||||||
| Annex 6300 requires operator attention. The LED is flashing | |||||||
| when there is a problem. |
|
|
|
|
|
| |
STAT | The STAT (Status) LED is green and ON after the Remote Annex | |||||||
| 6300 passes the core | |||||||
| resetting the Remote Annex 6300. |
|
|
|
|
|
| |
TRAF | The TRAF (Traffic) LED is green and flashing when the Remote | |||||||
| Annex 6300 successfully transmits or receives data from the | |||||||
| LAN. |
|
|
|
|
|
| |
SETUP | The SETUP LED is green when the |
|
|
|
|
| button is pressed ON | |
| Reset |
| ||||||
|
|
| ||||||
| (Setup mode) and flashing when the |
|
|
|
| button is pressed ON | ||
|
| Reset |
|
| ||||
|
|
|
|
| ||||
| for 3 seconds (Reset Mode). |
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
The Reset button is used to:
❑Enter Setup Mode.
When the Reset button is pressed (ON), the SETUP LED is green and the Remote Annex 6300 enters Setup mode. In this mode, configuration data is entered via the Console Terminal prior to booting the operational software.
❑Reset the Remote Annex 6300.
When the Reset button is pressed and held for 3 seconds, the SETUP LED flashes and the Remote Annex 6300 begins to execute its