Chapter 3 ROM Monitor Commands
addr
The addr command displays and sets several Remote Annex 6300 operating parameters (EEPROM values) relevant to IP network addressing:
❑Internet address.
❑Subnet mask.
❑Broadcast address.
❑Preferred Load Host address.
❑Preferred Dump Host address.
❑Load/Dump Gateway address.
❑Type of IP Packet encapsulation.
❑Load Broadcast
The addr -dcommand displays the unit’s ROM-resident Ethernet address in hexadecimal notation. (For a description of Internet addresses, see the Remote Annex Administrator’s Guide for UNIX.) The command syntax is:
addr [–d]
If you enter the addr command without the –dargument, the console prompts you for each Internet address. Enter Internet addresses using the standard decimal dot (.) notation.
The addr –dcommand displays the Remote Annex 6300’s Ethernet address, IP address, subnet mask, broadcast address, preferred load host address, preferred dump host address, load/dump gateway address, IP encapsulation type, and Load Broadcast. The addr -dcommand cannot be used to make changes to any of the displayed parameters.
Remote Annex 6300 Hardware Installation Guide | 3-5 |
