Chapter 2 Installing the Remote Annex 6300
If the ATTN LED is ON or flashing, one of the following failures has occurred (see Chapter 4 for more details):
❑Remote Annex hardware failure; contact technical support.
❑Network or network interface failure; error message displays on the console.
If a network or network interface failure occurs, typing q accesses the ROM Monitor prompt. Check the network connection and then see net on page
3Verify the Remote Annex 6300’s hardware configuration.
At the monitor prompt on the console, type config and press
Return . The screen display looks similar to this:
|
|
| REVISION/CONFIGURATION INFORMATION |
|
|
|
| |||||
ROM Software Rev: | 1002 |
|
|
|
|
|
|
|
|
|
| |
Board ID: 63 |
|
|
| Board Type: RA6300 |
|
|
|
|
| |||
CPU Type: 486DX2 |
|
| Ethernet Address: |
|
| |||||||
Memory size: | 8 Meg |
|
| EEPROM size: 65504 |
|
|
|
|
| |||
Flash size: 2 Meg |
|
| Flash ID: 8989 |
|
|
|
|
|
| |||
Available Interfaces (* = selected) ThickNet ThinNet *Twisted Pair |
|
| ||||||||||
SLC Local DRAM Size: 4 Meg | SLC SRAM Size: 128K |
|
|
|
|
| ||||||
TDM Interface: PRI T1 USA | Revision: VERSION A MGR=1.117 |
|
|
| ||||||||
Modem Country Code: 63 |
|
|
|
|
|
|
|
|
|
| ||
Port # | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 |
Modem ID | 2883 | 2883 | 2883 | 2883 | 2883 | 2883 | 2883 | 2883 | 2883 | 2883 | 2883 | 2883 |
Mod Status | OK | OK | OK | OK | OK | OK | OK | OK | OK | OK | OK | OK |
Port # | 13 | 14 | 15 | 16 | 17 | 18 | 19 | 20 | 21 | 22 | 23 | 24 |
Mod ID | 2883 | 2883 | 2883 | 2883 | 2883 | 2883 | 2883 | 2883 | 2883 | 2883 | 2883 | 2883 |
Mod Status | OK | OK | OK | OK | OK | OK | OK | OK | OK | OK | OK | OK |
|
|
|
|
|
|
|
|
|
|
|
|
|
This display is typical for T1 versions. For E1, information, 32 ports will be shown. For versions without modems, no port or modem information will be shown.
