Nortel Networks 6300 manual Attaching the Mounting Bracket to the Remote Annex

Chapter 2 Installing the Remote Annex 6300

Attaching the Mounting Bracket to the Remote Annex 6300

Attach the rear mounting bracket to the Remote Annex 6300 as follows:

1Remove the mounting brackets and hardware kit from its package.

2Remove two screws from the rear of the cover on each side of the Remote Annex 6300, as shown in Figure 2-3. Save these screws; you will need them later to install the rear mounting bracket.

3Install rear mounting brackets to the device using the four screws previously removed and the additional hardware supplied in the hardware kit.

4Tighten the screws to secure the bracket to the device.

Bracket Mounting

(2 Screws each side)

Bracket Assembly

(2 Screws, 2 Nuts, and

4 Washers each side)

Figure 2-3. Attaching the Mounting Bracket to the Remote Annex 6300

Remote Annex 6300 Hardware Installation Guide 2-5