Nortel Networks 6300 manual Setup Mode Error States

Activity TE2: Hardware Failure

Activity TE7: Booted Wrong Image

Chapter 4 Troubleshooting Procedures

Setup Mode Error States

Table 4-5 contains a description of the LEDs that are used to describe errors that occur at different stages of the system start-up process. If the Remote Annex 6300 fails while testing the hardware, (state T2), the error condition is hardware failure TE2. A description of each error condition follows Table 4-5.

Table 4-5. Normal Mode Error LED States

	STAT	ATTN	TRAF
Activity	Green	Amber	Green
TE2: Hardware Failure	◆	◆	✕
TE7: Booted Wrong Image	●	◆	✕

Key:

●On continuously.

✕Off.

■Flashing irregularly.

◆Flashing regularly (about 1Hz).

The ROM diagnostics detected a Remote Annex 6300 hardware problem requiring service. Call Customer Support.

The Remote Annex 6300 loaded an inappropriate image. Press the Reset button for 3 seconds to reset the device. Following is a list of

ways to prevent this problem in the future:

❑Be sure that you configure the Remote Annex 6300 with the appropriate image.

❑Be sure that the image you are booting has the right name. Don’t rename the image file unless you are making a copy for safe keeping.

❑If you used an na, admin, or cli boot command, specify the correct image and a valid filename.

Remote Annex 6300 Hardware Installation Guide 4-9