Nortel Networks 6300 manual Before you Begin, Installing the Remote Annex

Chapter 2 Installing the Remote Annex 6300

This chapter describes how to install your Remote Annex 6300 hardware and connect it to your Ethernet network. Setting up the Remote Annex 6300 consists of:

❑Installing the Remote Annex 6300 in a Rack (Optional)

❑Connecting a LAN

❑Connecting a Console Terminal

❑Connecting a PRI ISDN Interface

❑Powering Up and Testing the Remote Annex 6300

❑Installing the Software and Loading the Operational Image

❑Auto-initializing the ROMs

❑Self-booting the Remote Annex 6300

❑Invoking a Console Monitor

Before you Begin

The Remote Annex 6300’s software and operational image can be installed on two different devices. Table 2-1 outlines the different configurations the Remote Annex 6300 supports.

Table 2-1. Remote Annex 6300 Configuration Options

	Remote Annex
	6300 Must be	Input Device used to
Device on which the Operational	Connected to	Enter Installation
Software and Image is installed	the Network	Parameters
UNIX Load Host	Yes	Console
Remote Annex 6300 Flash ROM	No	Console
(Self-booting)

Remote Annex 6300 Hardware Installation Guide 2-1