Nortel Networks 6300 manual ROM Monitor Commands

Chapter 3 ROM Monitor Commands

Table 3-1. ROM Monitor Commands (continued)

Command	Description	Use
boot [-l] [<file>]	Erases the existing	Upgrading or
	Flash memory and	replacing the Flash
	copies a new image to	image.
	Flash.
config	Displays the current	Identifying your
	hardware	hardware, memory,
	configuration and	and ROM versions.
	revision levels.
console-baud	Changes the console	Configuring the
	port’s baud rate.	console port for remote
		maintenance.
erase	Erases non-volatile	Loading a new image
	memory.	and need to erase the
		old image.

help

image [-d <file>]

ipx [-d]

(not supported in this release)

lat_key [-d]

Displays the list of	Referencing the ROM
ROM Monitor	monitor commands.
commands.
Displays and/or sets	Loading an image that
the load image and	differs from the
tftp load dump names.	default.
Displays and sets	Changing Novell/IPX
EEPROM values	configuration
relevant to Novell/IPX	parameters. This
network addressing,	command is not used
including the IPX	for this configuration
load/dump file server.	of the Remote Annex
	6300.
Sets the LAT key.	Connecting to a DEC
	VMS host.

(continued on next page)

Remote Annex 6300 Hardware Installation Guide 3-3