Home Automation OmniPro II Leviton Scene Control, Scenes, Scene Commands, Scene Set Command, Page

NOTE: The All Off function can be changed, if desired - See Set Up Misc, All On And All Off.

Leviton Scene Control

OmniPro II supports Leviton Scene Control (a feature found in certain Leviton Switches). There are 256 Scenes that can be set and executed. The Leviton Switches are divided into "lighting groups" of four units each. Each of these lighting groups can be set to four different Scenes. Once the Scenes have been set up, a command can be sent to the units in that Scene to simultaneously return to the preprogrammed lighting level.

Scene

There are 256 Scenes that can be set and executed. The X-10 units (unit numbers 1-256) are divided into "lighting groups" of four units each. Each of these lighting groups can be set to four different Scenes. Scenes 1-4 apply to the first four unit numbers (units 1-4), Scenes 5-8 to the next four unit numbers (units 5-8), and so on. Thus an easy correspondence is made between Scene numbers and unit numbers.

SCENES

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

1

X

X

X

X

2

X

X

X

X

3

X

X

X

X

4

X

X

X

X

5

X

X

X

X

6

X

X

X

X

7

X

X

X

X

8

X

X

X

X

NUMBERS

9

X

X

X

X

10

X

X

X

X

11

X

X

X

X

12

X

X

X

X

13

X

X

X

X

UNIT

14

X

X

X

X

15

X

X

X

X

16

X

X

X

X

X - Corresponds to the unit numbers in a Scene.

Scene Commands

Scene Commands are used to Set Scenes, issue a Scene On command, and issue a Scene Off command. To issue Scene Commands, press the 2 (SCENE) key. You are prompted to enter a Scene number.

ENTER SCENE: 1-256

Enter the Scene number (1-256) followed be the ' # ' key.

SCENE 1

0=OFF 1=ON 2=SET

Scene Set Command

The Scene Set command is used to set up Scenes for a lighting group. Set the desired lighting level for each of the units in the lighting group for the first Scene. The desired lighting level may be set manually at the switch, or by a command issued from the controller. After the desired lighting levels are set, press the 2 (SET) key to save the first Scene for that group. Commands are sent to each of the four units in that group to instruct each unit to save its current lighting level as the lighting level for the Scene. Repeat these steps to set up each of the remaining three Scenes for that lighting group.

Scene On Command

Once the Scenes have been set up, press the 1 (ON) key to command the four units in that Scene to return to the lighting level set by the Scene Set command for that Scene.

Page 27