Chapter 2 Installing the Remote Annex 6300

Connecting the PRI ISDN Interface

A PRI ISDN Interface is used to connect the Remote Annex 6300 to an ISDN line. Follow the steps in this section to connect the ISDN line to the PRI ISDN Interface port located on the rear panel of the Remote Annex 6300.

1Plug the RJ48C connector located on the PRI ISDN Interface Cable into the PRI ISDN Interface port located on the rear panel of the Remote Annex 6300 (see Figure 2-11).

When the connector clicks into place, the connection is secure. Appendix A describes the PRI ISDN Interface port’s signal/pin allocation.

Figure 2-11. Connecting the PRI ISDN Interface

Remote Annex 6300 Hardware Installation Guide

2-13

Page 49
Image 49
Nortel Networks 6300 manual Connecting the PRI Isdn Interface