Nortel Networks 6300 manual Installing the Remote Annex

Chapter 2 Installing the Remote Annex 6300

2Plug the 8-pin connector into the console port located on the back panel of the Remote Annex 6300 (Figure 2-10).

When the connector clicks into place, the connection is secure.

Appendix A describes the console port’s signal/pin allocation.

Figure 2-10. Connecting a Console Terminal

3Turn on the console terminal and set the terminal to 9600 baud, eight data bits, no parity, one stop bit, and XON/XOFF flow control.

The ROM Monitor assumes that this terminal is CRT-based and displays the backspace (BS) character accordingly. See Chapter 3 for information on invoking the ROM monitor.

2-12 Remote Annex 6300 Hardware Installation Guide