Nortel Networks 6300 manual Mop -d, Mop command display looks like this

Chapter 3 ROM Monitor Commands

mop

This release does not support this command.

The mop command sets the MOP load/dump address. This is useful when the loading the Remote Annex 6300’s operational image from a VAX VMS load host. The command syntax is:

mop [–d]

The mop command display looks like this:

monitor:: mop

Enter preferred MOP load/dump address [<uninitialized>]:: Load Broadcast Y/N [Y]::

The mop –dcommand displays the current MOP settings:

monitor:: mop –d

MOP preferred load/dump address: <uninitialized>

Load Broadcast: Y

3-22 Remote Annex 6300 Hardware Installation Guide