Nortel Networks 6300 manual Do not over-tighten these screws beyond 10 in-lbs. of torque

Appendix D Modem Upgrade Instructions

2Secure the cover by installing the 17 screws back into the cover, starting at the rear and working to the sides.

Do not over-tighten these screws (beyond 10 in-lbs. of torque).

Power-up and Test

The following instructions describe the power-up and test sequence.

1Reconnect all the cables, including:

❑The Ethernet cable

❑The PRI ISDN Interface cable

❑The console terminal cable

❑The power cord

2Turn on the unit’s power.

3Set the Remote Annex to Test mode by pressing and holding the

Reset button (located on the front panel) for three seconds (see Figure D-4).

The Remote Annex runs its ROM-resident power-up diagnostics.

															Remote Annex 6300																			Modem Config
																																		Status
																	Modem Status																13-16 9-12 5-8		1-4
																																	29-32 25-28 21-24 17-20
Bay Networks																																CD
	32	31	30	29	28	27	26	25	24	23	22	21	20	19	18	17	16	15	14	13	12	11	10	9	8	7	6	5	4	3	2	1
																																Tx/Rx
														Xylogics, a Bay Networks Company
																																	Network/Status
																																		Ararms	Attn
																	PRI Channel Status															Test	Sync	Los	Stat Traf
																																Red	Yel	Blu	Setup Power
	32	31	30	29	28	27	26	25	24	23	22	21	20	19	18	17	16	15	14	13	12	11	10	9	8	7	6	5	4	3	2	1		Reset

Reset

Button

Figure D-4. Setting the Remote Annex 6300 to Test Mode

D-6 Remote Annex 6300 Hardware Installation Guide