Nortel Networks 6300 manual Connecting Thin Ethernet Cable

Chapter 2 Installing the Remote Annex 6300

1Verify that both sides of the T-connector are connected to the Thin Ethernet cable.

If the Remote Annex 6300 is the last device on the Thin Ethernet segment, make sure that one side of the T-connector is connected to the cable and the other side is connected to a network terminator.

2Plug the T-connector on the Thin Ethernet cable (RG-58 coaxial cable) into the 10Base2 Ethernet connector located on the rear panel of the Remote Annex 6300.

3Twist the sleeve on the T-connector clockwise to lock the connection in place.

Figure 2-6. Connecting Thin Ethernet Cable

2-8 Remote Annex 6300 Hardware Installation Guide