Nortel Networks 6300 Addr command display looks like this, Addr -dcommand display looks like this

Chapter 3 ROM Monitor Commands

The addr command display looks like this:

monitor:: addr

Enter Internet address [<uninitialized>]:: 192.9.200.214

Internet address: 192.9.200.214

Enter Subnet mask [255.255.0.0]::

Enter Broadcast address [0.0.0.0]:: 192.9.200.0

Broadcast address: 192.9.200.0

Enter Preferred Load Host address [<any host>]::

192.9.200.88

Preferred Load Host address: 192.9.200.88

Enter Preferred Dump Host address [0.0.0.0]:: 192.9.200.88

Preferred Dump Host address: 192.9.200.88

Enter Load/Dump Gateway address [<uninitialized>]::

192.9.200.10

Load/Dump Gateway address: 192.9.200.88

Select type of IP packet encapsulation (ieee802/ethernet) [<ethernet>]::

Load Broadcast Y/N [Y]::

The addr -dcommand display looks like this:

monitor:: addr -d

Ethernet address (hex): 00-80-2D-00-18-B6

Internet address: 192.9.200.214

Subnet mask: 255.255.0.0

Broadcast address: 192.9.200.0

Preferred Load Host address: 192.9.200.88

Preferred Dump Host address: 192.9.200.88

Load/Dump Gateway address: 192.9.200.10

Type of IP packet encapsulation: <ethernet>

Load Broadcast: Y

3-6 Remote Annex 6300 Hardware Installation Guide