Nortel Networks 6300 manual Powering Up and Testing the Remote Annex

Chapter 2 Installing the Remote Annex 6300

Powering Up and Testing the Remote Annex 6300

Power-up and test your Remote Annex 6300 as follows:

1Verify the Remote Annex 6300’s operational power range.

Check that the power select switch is set to the 110V position for operation in the 90 to 130 VAC range, or to the 220V position for operation in the 180 to 260 VAC range (see Figure 2-12).

Power Select

Switch

			115
			ISDN PRI
CONSOLE	10BASE5	10BASE2	10BASET
			LINK

Figure 2-12. Verifying the Remote Annex 6300 Operational Power Range

Setting the power select switch incorrectly can damage the

Remote Annex 6300.

2Apply power.

Connect the female end of the power cord to the AC line socket. Connect the male end to an active AC line outlet (see

Figure 2-13). Turn the power switch on. The Power LED is now active.

2-14 Remote Annex 6300 Hardware Installation Guide