Nortel Networks 6300 manual Connecting the Power Cord

Chapter 2 Installing the Remote Annex 6300

The Remote Annex 6300 now runs its ROM-resident power-up diagnostics. The LEDs light and then turn off, except for some status LEDs.

The ROM-resident, power-up diagnostics take 2 to 3 minutes to complete.

If the diagnostics complete successfully, the Remote Annex 6300 either enters Setup Mode and waits for configuration data to be entered or boots its operational image from Flash.

Figure 2-13. Connecting the Power Cord

You can enter configuration information through a terminal connected to the console port. The ROM Monitor prompt (monitor::) appears on the terminal.

Remote Annex 6300 Hardware Installation Guide 2-15