Nortel Networks 6300 manual Setup Mode

Activity NE5:

Booted Wrong

Image

Chapter 4 Troubleshooting Procedures

The Remote Annex 6300 loaded the wrong image. Press the Reset button for 3 seconds to reset the device. Following is a list of ways to prevent this problem in the future:

❑Make sure that you configure the Remote Annex 6300 with the appropriate image.

❑Be sure that the image you are booting has the right name. Don’t rename the image file unless you are making a copy for safe keeping.

❑If you used an na, admin, or cli boot command, specify the correct image and a valid filename.

If you do not know why the Remote Annex 6300 booted the wrong image, enter Setup mode and issue an image -dcommand. The command display will list the image file the Remote Annex 6300 is trying to load.

Setup Mode

Enter Setup mode by pressing the Reset button located on the Remote Annex 6300 front panel. Press this button within 30 seconds of resetting or powering up the device.

Setup Mode Error-free Sequence

Table 4-4 summarizes the LED sequences that display in Test mode during an error-free start-up. A description of each sequence follows Table 4-4.

Remote Annex 6300 Hardware Installation Guide 4-7