Nortel Networks 6300 manual See Table

Chapter 4 Troubleshooting Procedures

Table 4-6. Errors from Last ERPC Layer Invocation

Error	Description
H/W errors	The Remote Annex 6300 sensed a hardware error during
	message transmission or reception. This error indicates a
	fault with the Remote Annex 6300 LAN interface. Use the
	net command to isolate the problem (see page 3-23).
Msgs from	The Remote Annex 6300 received a message from an
wrong host	incorrect host. This indicates that the Remote Annex 6300
	received, and ignored, an unsolicited packet.
Rsp T/O’s	The Remote Annex 6300 never received a correctly
	formatted response from the correct host, or any
	response from any load server hosts.
Msgs of	The correct host sent a message to the Remote Annex
wrong type	6300, but the message was not a correctly formatted
	response to the transmitted request.

Table 4-7. Errors from Last Read Request

Error	Description
Msgs with wrong	The correct host responded to the Read Request,
size	but the data size is incorrect.
ERPC layer errors	See Table 4-6.
Aborts rx’d	The host’s BFS transmitted an abort in response to
	the Remote Annex 6300’s Read Request. Run
	erpcd –Don the host to obtain more information.

4-12 Remote Annex 6300 Hardware Installation Guide