Electrolux 311423202

This appliance is designed to be installed with an appliance flexible connection only. Supply piping should not

be less that R³/8. Connection is made to the Rc ½ (½" B.S.P.) female threaded entry pipe located just below

the hotplate level on the rear left hand side of the appliance. NOTE: ONLY LIQUID SEALANTS TO BE

USED WHEN INLET GAS PIPE IS FITTED TO RESET VALVE I.E.: DO NOT USE P.T.F.E. SEALANT

TAPE.

Check for gas soundness after connecting the gas supply.

The gas bayonet connector must be fitted in the shaded area indicated in Fig. 4. Take into account that it

must be possible to pull the appliance forward sufficiently. The hose must not get caught on the stability

bracket.

IMPORTANT: FLEXIBLE TUBING USED MUST COMPLY WITH BS. 669 CURRENT EDITION.

L.P.G. FLEXIBLE CONNECTIONS MUST BE OF A TYPE SUITABLE FOR L.P.G. AND CAPABLE OF

OPERATION UP TO 50 mbar AND TO CARRY A RED STRIPE, BAND OR LABEL.

1. The battery is located on the left hand side of the front plinth and can be viewed through a slot in the

bottom left hand corner of the front frame( Fig 5.)

2. To gain access to the battery, open the main oven door, rotate the battery holder clockwise.

3. Fit the battery AA size ensuring the positive, + terminal is on the right hand side as shown in the

diagram. Return the battery to original position by turning it anti-clockwise.

G R O S V E N O R

Fig.5

200

250

Fig.4