Network Setup

Initial Setup via a

Crossover Cable

This section provides a guide on how to connect the IP Smart Dome to your PC/laptop for initial setup.

Please follow the instructions in the order they appear, without skipping steps. Do not supply power to the IP Smart Dome, until instructed.

In order to access the IP Smart Dome’s firmware you will need to connect the IP Smart Dome Camera directly to a PC or laptop computer via the supplied crossover cable.

1.Before you begin, you must determine the current network/INTERNET (TCP/IP) settings on the PC or laptop you plan to setup the IP Smart Dome. Jot down your entries below for quick reference.

Current TCP/IP Settings

IP Address

Subnet Mask

Default Gateway

Primary DNS Server

Secondary DNS Server (Option)

2.In order for the IP Smart Dome to communicate with your PC, you have to change your PC’s IP address and subnet mask

We recommend that you change your IP address to 192.168.1.11 and change the subnet mask to 255.255.255.0

Leave all other entries (Default Gateway, DNS Servers, etc.) blank.

3.After you have made the changes to your IP address and subnet mask, you may then attach the IP Smart Dome to your PC via the supplied crossover cable. Plug-in either end of the crossover cable into the PC’s network card and the other end into your IP Smart Dome.

4.After connecting the PC and IP Smart Dome using the crossover cable, power on the IP Smart Dome by plugging in the power supply shipped with the IP Smart Dome.

5.No longer than 1 minute after powering on the IP Smart Dome, verify that the ACTIVE indicator light is flashing, and the LINK indicator light is flickering or solid.

6.Now you will be able to access the viewer software within the IP Smart Dome.

Open Internet Explorer and type the IP address of 192.168.1.200 (default IP of the IP Smart Dome from the factory) into the Address Bar of the web browser (as seen below). Press Enter.

If a message appears after pressing “Enter” similar to the image depicted below, choose “Try Again”. This message will vary depending on the operating system.

7.Now you will be able to see the login screen for the IP Smart Dome.

8.The default ID is “root, default Password is “4321”. (without the “”)

9.If at any time you are prompted to download ActiveX controls, you must click ‘Yes’, all content is safe.

You will have to click “Yes” twice to two individual prompts. This allows your video to be displayed in Internet Explorer.

English – 33

Page 33
Image 33
Samsung SNC-C7478P manual Initial Setup via a Crossover Cable