Samsung SNC-C7478P manual User

Setup Tool

camera using the web browser. The default port number is 80(TCP).

❖Device Port (TCP)

•A port used to control video transmission. The default value is 60001(TCP).

❖TCP Streaming Port

•A port used to transfer video using the TCP protocols. The default value is 60002(TCP).

❖UDP Streaming Port

•A port used to transfer video using the UDP protocols. The default value is 60003(UDP).

❖Upload Port(TCP)

•A port used to upgrade software. Default value is 60004(TCP).

❖IPv6 Enable

•IPv4 and IPv6 may be enabled simultaneously. When IPv6 is enabled, your camera will receive an IP address according to the configuration in the network router.

❖Multicast Address

•Shows IP address set for video transmission using UDP Multicast.

The default value is 225.128.1.128. It is recommended to set it to between 224.0.0.0 and 239.255.255.255.

❖Multicast Port

•Shows UDP port set for video transmission using UDP Multicast. The default value is 60005(UDP).

❖TTL

•TTL stands for “Time To Live” that allows you to set the number of routers so that the packet can pass through. Each router decreases the TTL value one by one when a packet passes it through. If the TTL value reaches 0, the packet cannot pass through a router. The default value is 63. It is recommended to set it to between 0 and 255.

❖RTSP Port

•Set up the RTSP port number to use. The default value is 554.

❖RTP Port Range

•Set up the range of port number to use for RTP Protocol.

The Start number of RTP Port has to be even number and the last number must be greater than the start number +4. I.e. the difference should be at least 4.

❖RTP Multicast Address

•Set up IP Address for RTP/UDP Multicast.

❖RTP Multicast Port

•Set up Port number used in RTP/UDP Multicast. It is noted that RTP Multicast Port must be a even number.

❖RTP Multicast TTL

•Set up TTL for RTP/UDP Multicast. TTL is a number between 0 ~ 255.

USER

❖Login Authentication

•You can determine whether to require login authentication for users.

If it is set to <Enable>, the users can connect to the system through login authentication, while it is set to <Disable>, the users can connect to the system without login authentication. However, users connected to the system without login have USER permission.

When the setting is complete, click the [Apply] button.

❖User Login ID/Password List

•Shows user ID, password and level (permissions) in a list.

You can register up to 10 users. The default administrator ID is root. <Administrator> cannot be deleted or added and you can change the password only.

M  For the ID and password, up to 9 alphanumeric and some special characters are allowed.

You cannot register a duplicated user ID.

You cannot register root or guest user ID.

About User Level

Administrator	The Administrator can use all
	functions and change the ptz control,
	setup or search.
Operator	The Operator can use all function
	except setup and search functions.
User	The User can monitor video only.

42 – 36x IP Smart Dome Camera