Samsung SNC-C7478P Installation, DIP Switch Setup, Communication Protocol Setup, Camera ID Setup

Installation

DIP Switch Setup

Before you install the camera, you should set the DIP switches to configure the camera ID, communication protocol.

❖Communication Protocol Setup

ON ON

1 2 3 4 5 6 7 8

WŸw™–›–Š–“WWGaGhœ›–Gw™–›–Š–“

WX GwŒ“Š–Tk

WŸWYGaGwŒ“Š–Tw

WŸWZGaGzhtzun

iˆœ‹Gyˆ›ŒWŸWWGaGY[WW WŸWXGaG[_WW WŸWYGaG`]WW WŸWZGaGX`YWW WŸW[GaGZ_[WW

yzT[_\ {Œ™”•ˆ›Œ

pkGzŒ››•ŽGOX¥Y\\P

•Select the appropriate Protocol with DIP switch combination.

	Switch State			Protocol
Pin1	Pin2	Pin3	Pin4
OFF	OFF	OFF	OFF	Auto Protocol
ON	OFF	OFF	OFF	PELCO-D
OFF	ON	OFF	OFF	PELCO-P
ON	ON	OFF	OFF	SAMSUNG

•	If you set the protocol as Auto Protocol, camera will
	automatically recognize the kind of Protocol.
•	If you want to control using DVR or system keyboard, their
	protocol must be identical to camera. Otherwise, you can
	not control the camera.
• If you changed camera protocol by changing DIP S/W, the
	change will be effective after you reboot the camera.

❖Camera ID Setup

ON ON

1 2 3 4 5 6 7 8

•ID number of camera is set using binary number. The example is shown bellow.

Pin	1	2	3	4	5	6	7	8
ID Value	1	2	4	8	16	32	64	128
ex) ID=5	on	off	on	off	off	off	off	off
ex) ID=10	off	on	off	on	off	off	off	off

•The range of ID is 0~255. Factory default of Camera ID is 1.

•If you want to control a certain camera, you must match the camera ID with Cam ID setting of DVR or Controller.

• Factory default of protocol is “Auto” Protocol

❖ Communication Baud rate Setup

ON ON

1 2 3 4 5 6 7 8

•Select the appropriate Baud rate with DIP switch combination.

	Switch State			Protocol
Pin5		Pin6	Pin7
OFF		OFF	OFF	2400 BPS
ON		OFF	OFF	4800 BPS
OFF		ON	OFF	9600 BPS
ON		ON	OFF	19200 BPS
OFF		OFF	ON	38400 BPS

• Factory default of Baud rate is “9600 BPS”

English – 11