Behringer LX1200H/LX210 manual Installation, Mains voltage, Audio connections

V-AMPIRE LX1200H/LX210

8.INSTALLATION

8.1Mains voltage

Before connecting the unit to the mains, please make sure that the voltage setting on the unit matches the local voltage! The fuse holder at the AC power connector has 3 triangular markings. Two of these three triangles are aligned with one another. The unit is set to the voltage shown next to these markings and can be switched over by turning the fuse holder by 180°. IMPORTANT: This does not apply to export models designed exclusively for 120 V operation!

+If you set the unit to a different mains voltage, be sure to use a fuse of the correct type and rating. Please refer to chapter 9 “SPECIFICATIONS” for details.

+Blown fuses must be replaced by fuses of the same type and rating! Please refer to chapter 9 “SPECIFICATIONS” for details.

The mains connection is made using the enclosed power cord and a standard IEC receptacle. It meets all of the international safety certification requirements.

+Please make sure that all units have a proper ground connection. For your own safety, never remove or disable the ground conductor from the unit or of the AC power cord. The unit shall always be connected to the mains socket outlet with a protective earthing connection.

8.2 Audio connections

The inputs of your V-AMPIRE come as mono 1/4" connectors. All line out, line in and headphones outputs are configured as 1/ 4" stereo connectors. The line outputs work with both balanced and unbalanced connections.

The DI OUT outputs of your V-AMPIRE are on XLR connectors.

Fig. 8.1: XLR connectors

Fig. 8.2: 1/4" TS connector

Fig. 8.3: 1/4" TRS connector

Fig. 8.4: Headphone connector

16 8. INSTALLATION