16iNUKE NU6000DSP/NU3000DSP/NU1000DSP User Manual
Programming BEHRINGER Amp Remote Software for
1.Select the Configuration tab.
2.Choose the
3.Click “Yes” on the Amp Mode confirmation window.
4.Select the Filter/Crossover tab.
5.Select the
6.Click “Yes” in the confirmation window. The
7.Choose a filter type from either the Low Pass 2 or High Pass 3 Type pulldown menus (the software defaults to a Butterworth filter). Any changes to the Low Pass 2 or High Pass 3 settings will also automatically appear in both filter’s Control View settings.
8.Choose a filter slope setting from the Slope pulldown menu under either Low Pass 2 or High Pass 3 (the software defaults to a Butterworth filter).
Again, matching parameters will automatically appear in both filter’s Control View settings.
9. Set the crossover frequency by using any of these three methods:
a)Rotate the Low Pass 2 or High Pass 3 virtual Freq knobs in the Control View. The crossover frequency displayed in the Freq box below the virtual knob will change simultaneously for both filters.
b)Select the text box below either Freq virtual knob, and type your desired frequency directly into the text box.
c)Go to the Frequency Curve display, click on the frequency line marked “2,” and drag the frequency line to the desired area of the Frequency Curve. Parameter settings and virtual knobs in the Control View will automatically move and change as you drag the crossover frequency through the Frequency Curve window.
10.If necessary, adjust the Gain settings for Channel A and Channel B by rotating the respective Gain virtual knobs.
NU3000DSP |
XLR balanced
XENYX 1202FX
NU3000DSP
XLR balanced
| |
EUROLIVE | B1800X PRO Front |
B1520 PRO |
|
| |
EUROLIVE | B1800X PRO Front |
B1520 PRO |
|
B1800X PRO Rear | B1800X PRO Rear |