8.Thewashing machine must not be used in
theopen or in an area of high humidity as
waterdroplets may form on the electrical
components.Air dry the appliance if the
washingmachine components become wet.
9.The washing machine should be placed
ina well-ventilated area, leaving a space
betweenthe appliance and adjacent walls or
furniture.
10.Keep away from heat sources and direct
sunlightto prevent plastic and rubber com-
ponentsfrom ageing.
11.During installation, ensure that the
electriccable is not trapped by the washing
machineand damaged.
1.Make sure that the washing machine is
securelyconnected to the water supply. Take
thenecessary precautions or contact the lo-
calservice centre if the connection is poor or
thereis a water leak.
2.Fasten the door handle before opening the
doorand then close the porthole. Do not shut
thedoor violently.
Matters needing attention

Use

Dearcustomer, For the machine and your
ownsecurity, DO NOTREPAIR IT BY YOUR-
SELF!DO NOT USE THE WASHING MA-
CHINEWHICH SOME PARTS ARE LOST!
Trouble shooting
Thefollowing circumstances do not constitute problems. Do not contact the maintenance
serviceuntil the problem has been confirmed.
problem PossibleCause
Poorconnection to power supply
Powerfailure
Dooris not closed properly
Machinehas not been switched on
Thewashing machine fails to
operate
Thewashing machine does not
fillwith water
Thewater supply and drainage
donot stop
Drainagefailure
Strongvibration during spin
drying
Operationstops before com-
pletionof the wash cycle
Excessivefoam in the drum
Failureof the drying process
Incompletedrying
Wateris not turned on
Waterpressure is less than 0.05MPa
Theinlet hose has a kink
Watersupply failure
Thedoor is not closed properly
Checkthat the height of the water hose is within 80-100cm
Checkthat the drain hose is not syphoning
Drainagehose is blocked
Drainagehose end is more than 100cm above the floor
level
Checkthat all packing bolts have been removed
Thewashing machine is located on an uneven surface of
isnot level
Checkthat all foam packing has been removed from the
motor
Waterof electricity failure
Poorconnection to the power source
Thedetergent is not a low foam type
Excessivedetergent has been used
Dooris not closed properly
Programhas not been correctly set
Checkto see if the end of the water drainage hose is
submergedin water
Thefilter is blocked
Themachine is overloaded
Thewater tap is not tured on
2 15