EUROLIGHT LC2412
Fig. 2.1: Section overview
Fig. 2.2: A PRESET section (detail)Faders
UPPER switch. When you press this switch, the A PRESET section is switched to the twelve additional channels. After that, you can set up the intensity of channels 13 - 24. See also chapter 3.2.
Setting up presetsChannel faders are used for setting up a preset that can bedirectly recalled by moving fader A
. As in all other setups,the MAIN fader 
(see chapter 2.6) determines the maximum illumination level of selected light sources.
The faders of the B MEMORY section are located in the block underneath the A PRESET section.
These faders control the illumination level of an entire group of channels in a ratio to one another that you previously determined by setting up the A PRESET faders and saving this setting as a memory.
Exception: When the LC2412 is in preset mode (“P” shown in the bank display), the faders control the same channels as the faders of the A PRESET section. This way, you can simultaneously create a second preset.
- 
These faders are also a part of this section, but they have a double function. When the LC2412 is in sound to light mode (party light function), they control the illumination level of individual memories assigned to particular frequency ranges.
The BANK display shows the storage bank to which the memories you recall belong. It also shows if the LC2412 is currently in preset mode (“P” diplayed). The display starts flashing when you switch into preset mode, and lights up constantly after three seconds. The preset mode is active only after the flashing has stopped. This prevents accidental activation of the preset mode as well as rough fades.
2. CONTROL ELEMENTS | 7 |