Water connections

a) Water inlet hose

The specific hoses that come with the machine are connected to the water inlet valves on the machine. Red labeled hose is for hot water inlet and blue labeled hose is for cold water inlet.

"If you are going to use your double water- inlet machine as a single (cold) water-inlet unit, you must install the stopper*, sup- plied with your machine to the hot water valve.

If you want to use both water inlets of the product, you can connect the hot water hose after removing the stopper and gas- ket group from the hot water valve.

*Applies for the products supplied with a blind stopper group. "

Since the connection points are under water pressure, turn on the taps to the maximum after the connection. Check if there is any water leakage at the connec- tion points. In order to prevent the water leakages and the damages they may cause, keep the taps closed when you are not using the machine.

Minimum 1 bar and maximum 10 bars of water flow from the tap is enough for your machine to operate efficiently. (In practice, 1 bar means that more than 8 liters of wa- ter per minute flows from a full open tap.)

Install the elbowed end of the hose to your machine. Hand-tighten the nuts of the hose, do not use a spanner

Models with double water inlets can be used as a model with a single water inlet by using a plug. Plug should be installed to the hot water valve. A rubber gasket should be used in order to prevent water leakage from the connection point.

Do not connect the product with single water inlet to the hot water tap. The prod- uct may switch to the protection mode if the temperature of the water connected to a product with double water inlet through a Y part and single water inlet is above 40°C.

a) Water drainage hose

Water drainage hose can be attached to the side wall of a sink or bathtub. Hose should not be bend. When the drainage hose is hanged on a sink or bathtub, it can be secured with a hose bracket so that it will not fall.

The end of drainage hose can be connected directly to the waste water drainage hole or to the specific end that is installed to the outlet elbow of the sink.

The hose should be installed to a height of 40 cm minimum and 100 cm maximum.

0 10 20 30 40 50 60 70 80 90 100 110

8

EN

Page 8
Image 8
Beko 2012 CX, 2112 CX manual Water connections