Beko CXFD 6113 S Installation, Points to be considered, when re-transportingyour, refrigerator

3	Installation
B			3. Clean the interior of the refrigerator as
Please remember that the			recommended in the “Maintenance
	manufacturer shall not be held liable if
	the information given in the instruction		and cleaning” section.
	manual is not observed.		4. Plug the refrigerator into the wall
Points to be considered			outlet. When the fridge door is open,
			the fridge compartment interior light
when re-transporting your
			will come on.
refrigerator
			5. You will hear a noise as the
1. Your refrigerator must be			compressor starts up. The liquid and
	emptied and cleaned prior to any		gases sealed within the refrigeration
	transportation.		system may also give rise to noise,
2. Shelves, accessories, crisper and etc.			even if the compressor is not running
	in your refrigerator must be fastened		and this is quite normal.
	securely by adhesive tape against any		6. Front edges of the refrigerator may
	jolt before repackaging.		feel warm. This is normal. These
3. Packaging must be adequate and			areas are designed to be warm to
	the rules of transportation printed on		avoid condensation
	the package must be followed.		Electric connection
Please do not forget…			Connect your product to a grounded
Every recycled material is an
			socket which is being protected by a
	indispensable source for the nature
			fuse with the appropriate capacity.
	and for our national resources.
			Important:
If you wish to contribute to recycling
	the packaging materials, you can		• The connection must be in
	get further information from the		compliance with national regulations.
	environmental bodies or local		• The power cable plug must be easily
	authorities.		accessible after installation.
Before operating your			• The specified voltage must be equal
refrigerator			to your mains voltage.
Before starting to use your refrigerator			• Extension cables and multiway plugs
			must not be used for connection.
	check the following:		BA damaged power cable must be
1. Is the interior of the refrigerator dry			replaced by a qualified electrician.
	and can the air circulate freely in the
			BProduct must not be operated before
	rear of it?		it is repaired! There is danger of
2. Please install the 2 plastic wedges
			electric shock!
	as illustrated in the figure. Plastic
	wedges will provide the required
	distance between your refrigerator
	and the wall in order to allow the air
	circulation. (The illustrated figure is
	only an example and does not match
	exactly with your product.)	7	EN