LOG PLACEMENT
Before you begin — This unit is supplied with six (6) ceramic fiber logs. Do not handle these logs with your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling the logs, wash your hands gently with soap and water to remove any traces of fibers.
The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are not properly and firmly positioned in the appliance. Never add additional logs or embellishments such as pine cones, vermiculite or rock wool to the heater. Only use the logs and
Failure to position the parts in accordance with diagrams below or to use only parts specifically approved for this heater may result in property damage or personal injury.
INSTALLING CHARRED TIMBER LOGS ON BURNER
1. Place rear log (#1) on two pins located on the back of the grate. See Figure 23.
Pins
Rear Log (#1)
Figure 23 - Installing Rear Log (#1)
Right Base Log (#2)
2. Place right base log (#2) on two pins on right side of grate. See Figure 24.
Figure 24 - Installing Right Base
Log (#2)
Pins
22 | 23D8020 |
