Monessen Hearth DIS33G CONNECTING REMOTE RECEIVER Figure, Electrical Wiring Milli-Volt, Cover

ELECTRICAL WIRING (MILLI-VOLT)

CONNECTING REMOTE RECEIVER (Figure 21)

THESE INSTRUCTIONS SUPERCEDE THE SECTION

ENTITLED “HEARTH MOUNT” IN THE MILLI-VOLT

HAND-HELD REMOTE INSTRUCTIONS SUPPLIED

WITH THE REMOTE.

1. Remove cover on control panel to show opening for remote Remote

receiver.Receiver

2. Connect the remote connectors located in the unit.

3.Slide remote receiver in the opening of control panel. Use two screws provided to attach remote receiver to the control panel.

4.Replace Cover.

Cover

NOTE: Do not place remote in combustion chamber.

Figure 21 - Installing Remote Receiver

CHECKING SYSTEM OPERATION

The milli-volt system and individual com- ponents may be checked with a milli-volt meter having a 0-1000 mV range. Conduct each check shown in chart below by con- nection meter test leads to terminals as indicated.

		CONNECT
		METER	SWITCH OR	METER
CHECK	TO	LEADS TO	THERMOSTAT	READING
TEST	TEST	TERMINALS	CONTACTS	SHOULD BE
A	COMPLETE	2 & 3	CLOSED	CLOSED
	SYSTEM
B	THERMOPILE	1 & 2	OPEN	OPEN
	OUTPUT

A. COMPLETE MILLIVOLT SYSTEM CHECK

(“A” Reading - Thermostat contacts CLOSED - Control Knob “ON” - Main burner should turn ON)

a.If the reading is more than 100 milli-volts and the automatic valve still does not come on, replace the control.

b.If the closed circuit reading (“A” reading) is less than 100 millivolts, determine cause for low reading, proceed to Section B below.

B. Thermopile Output Reading Check

(“B” Reading - Thermostat contacts OPEN - Main burner OFF)

1.Check gas pressure to the unit. If gas pressure is within minimum and maximum on data plate, then check pilot voltage, 325 millivolts minimum. If the minimum milli-volt reading is not obtainable, replace pilot.

20 23D8020