Beko GNE 134620 X manual Installing Water Filter, Connection of the Water Pipe to the Refrigerator

Installing Water Filter

(in some models)

Two different water sources may be connected to the refrigerator for water supply: the mains cold water supply and water in a bottle. Installation Requirements

A pump should be used for bottle water usage.

Check that the parts stated below are supplied with your appliance.

1.Union for connection of the water pipe to the rear of the appliance. (If it does not fit, provide it from the nearest authorized service.)

2.2 pieces of pipe clips (In case required to secure the water pipe)

Note: Since the following parts are not required in use with a bottle, they may not be found in the product you purchased.

3.5-meter long water pipe (1/4 inch in diameter)

4.Cold mains water valve with mesh filter (Tap Adapter)

5.Water Filter or externally connectable filter to be fitted to the bracket inside the fridge compartment.

Place where the external filter is going to be fitted should be determined first.

3
4	5

2

1

11

(Applies to the filter being used outside the refrigerator.) Then, determine the distance between the filter and the refrigerator and required hose lengths from the filter to the refrigerator water inlet.

Water filter must be hold upright as shown in the figure. It is important to properly attach the filter to water inlet and water outlet points.

After attaching the filter, do not use first 3-4 glasses of water.

Connection of the Water Pipe to the Refrigerator

1.After installing the union onto the water pipe, insert the water pipe to the refrigerator inlet valve by pressing downwards firmly.

2.Fix union as seen in the opposite figure, by squeezing by hand on the refrigerator inlet valve.

(a- Water Pipe, b-Union, c-Valve) C Note 1: You should not need to tighten the union with a tool to achieve water tight assembly. In case of a leak use a spanner or a pair of pliers to tighten the union.

a

a

b

2

1

c

EN