8.Identify the Left Pedal (13). Attach the Left Pedal to the left Flex Bar (14) with an Adjustment Bolt (20), an M10 Washer (38), and an Adjustment Knob (15) as shown.
Note: The Left Pedal can be attached in any of five positions (see HOW TO ADJUST THE PEDALS on
page 9).
Attach the Right Pedal (not shown) in the same way. Make sure that both Pedals are in the same position.
8 |
|
| 20 |
13 |
|
14 | 38 |
| |
| 15 |
9. Make sure that all parts of the elliptical crosstrainer are properly tightened. | Note: Some hardware may |
be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the |
|
elliptical crosstrainer. |
|
INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor (refer to page 20), follow the steps below to install the receiver and the short jumper wire included with the chest pulse sensor.
1. Remove the two short screws and the two long screws
from the back of the Console (5). Lift off the front of the Console.
2.Plug the short jumper wire (A) into the indicated jack on the Console (5). Connect the other end of the short jumper wire to the wire on the receiver (B). Note: Any other wires included with the chest pulse sensor are
not needed.
Next, peel the paper off the adhesive pad on the back of the receiver (B). Orient the receiver as shown, and press it onto the Console (5) in the indicated location.
Refer to step 1 above. Reattach the front of the Console (5) with short screws and the long screws.
Make sure that no wires are pinched.
1 | 5 |
|
| Lift | |
|
| |
|
| Here |
| Short |
|
| Screws |
|
| Long |
|
| Screws |
|
2 | B |
|
|
| |
|
| Cylinder |
| 5 |
|
| Jack | A |
8
